Dewalt M-16 Nail Gun

Cordless Nail Gun Comparison Test

This DeWalt M-16 nail gun might not look anything like the computer game version, but it is able to send a 6-D nail through a 2 x 4 at 200 yards, literally allowing you to sit in your lawn while building a fence. Unfortunately, lifes not all that simple as I doubt you have the skill and accuracy required to achieve that, in addition to the fact that wayward nails might end up injuring somebody. The DeWalt M-16 nail gun will be equipped with a hundred-round magazine though, so make sure you are well protected when using this. This article was filed in Homepage > Gadgets .
For the original version including any supplementary images or video, visit http://www.ubergizmo.com/2008/07/dewalt-m-16-nail-gun/

DeWalt M-16 Nail gun: Blackwater meets Black & Decker

Or, rather, they come with 3/8-inch pneumatic hoses attachedworking with a finish gun usually means lugging around a cumbersome compressor tethered to a tube. But finish guns are changing. There are now a variety of cordless options available, each with a different fuel source. So how do they measure up to the traditional air-powered gun? By Doug Mahoney
For the original version including any supplementary images or video, visit http://www.popularmechanics.com/home/reviews/power-tools/cordless-nail-gun-comparison-test

Nail Gun Injuries Surge

The answer, as it turns out, comes down to teamwork. “Often, a person is on the opposite side of the wall, and their partner or coworker misses the stud, and the nail goes straight through the wall into their head.” Are Nail Guns Unsafe? Telephone requests for comments from spokespeople from four major nail gun manufacturers — DeWalt, Stanley, ITW and Senco — were not immediately returned. However, most would agree that no power tool is completely safe if used improperly. On this point, Lipscomb agrees.
For the original version including any supplementary images or video, visit http://abcnews.go.com/Health/story?id=3035560

DeWalt M 16 Nail Gun

Then, I went down to the DeWalt factory service place a few miles from the house to get a sticker. There, I saw they had brand new battery casings, so I picked up one of those too. I got home, found a short magazine , and got to work. Mr. Wiggins continued, describing the ingenious construction process he used to bring this Site Foremans nightmare to life.
For the original version including any supplementary images or video, visit http://www.guns.com/2011/04/12/qthats-not-a-nailgun-this-is-a-nailgunq/